Gate Switch | Smartlink | Security Gates | Home Automation

Mimolite Smart Gate Switch (Z-Wave) by Fortrezz

R1,995.00

This product is designed to work with the Smartlink Smart Home Hub
Gate Switch (Latch or momentary select-able for strike locks, mag locks or motorised gates)
INSTALLATION: DIY or local alarm installer

9 in stock

SKU: ZWMimLite Category: Brand:

Description

A momentary dry contact switch makes any gate, strike lock or mag lock Z-wave controllable.

The MIMOlite Module is an interface / bridge module, capable of converting a Z-WaveTM RF message input to a dry contact relay output.

MIMOlite comes in a plastic enclosure for indoor use only.

* Connect devices to your Home Security panel OR to your z-wave home automation network.
The MIMOlite module provides one relay output (isolated dry contacts, NO-COM-NC) and is capable of Z-WaveTM output/control. The system includes a program switch for Z-WaveTM inclusion/exclusion and an LED for various status indications.

The current triggered/un-triggered status can also be read via Z-Wave. The SIG1 input can be associated with up to two other Z-WaveTM devices, such that an associated device will automatically turn on (or off) based on the occurrence of a trigger event.

The output relay is, typically, commanded via Z-WaveTM commands. The relay activation can be set via a jumper or via ZWave for either momentary or latched operation – see Installation section of the User Manual.

This product is designed to work with the Smartlink Smart Home Hub.

Specifications

Frequency Range: 868.4MHz
Power: 9-16 V DC from a power supply @~ 300mA capability
Distance Range: Max 100ft line of sight in unobstructed environment
Input Signal 1 (SIG1): Digital or Analog Input 0 to 16V DC or 16 Hz Max for pulse counting (minimum 32 ms high or low time).
Input Signal Impedance: Input impedance for SIG1 is Z=66 ohm at 10KHz. This impedance is: 66 ohm = 34 ohm + j 540uH.
Output Relay 1: DPDT, Max. Switching power of 120W; 10uA to 10A; High Dielectric strength coil-contacts: 1,000 VAC
Open contacts: 750 VAC; Conforms to FCC Part 68 requirements; Ag + Au clad bifurcated contacts fully sealed.
Enclosure Size (L x W x D): 3 3/8″ (85mm) x 2 1/2″ (64mm) x 1 1/4″ (30mm)
Weight: 4 oz (100 gram)
Operating Temperature: -10⁰C (14F) to +70⁰C (158F)
System Requirement: Any Z-WaveTM -enabled network and controller.
* Complies with European Test standard: ETSI EN 300 220 for 868.4 MHZ Z-Wave RF communications.

Reviews

There are no reviews yet.

Be the first to review “Mimolite Smart Gate Switch (Z-Wave) by Fortrezz”

Your email address will not be published. Required fields are marked *